Hand Dryer Automatic — Sanitary Equipment Bobrick B-710E Compac

Hand Dryer Automatic — Sanitary Equipment Bobrick B-710E Compac

Construction:
Housing made of 2.6mm thick ABS plastic, light gray, fire retardant, shockproof.
The housing is attached to the base plate with three chrome-plated steel screws.
Base plate and fan housing made of 2 mm thick plastic, fire-retardant. Air intake grille is fitted into the underside of the base plate.
Air outlet grille is mounted between fan housing and base plate.
Fan dynamically balanced, air output 2.5 m3/min, maintenance-free motor, with automatically triggering overheating protection switch.
Chrome nickel coil heating element protected by thermal overload switch.

Operation/Control:
Electronic control via automatic infrared sensor: switches the dryer on automatically when hands are placed under the air outlet opening and in the sensor's detection area.
If you remove your hands from the detection area of ​​the sensor, the dryer switches off. The electronic sensor will turn off the dryer after approximately 2 minutes if an object such as tape or chewing gum is placed in front of the sensor eye. After removing this item, the electronic sensor will reset itself automatically and the dryer can operate normally again.

Dimensions:
Width 275mm
Height 280mm
Depth 130mm

Wall mounting with screws.

Noise level: 82DBa
 

Note: Bobrick automated hand dryers must be mounted 380mm above any projection or horizontal surface that may interfere with the operation of the automated sensor.

This model is not intended for areas where vandalism is likely.
 

*RECOMMENDED MOUNTING HEIGHTS
Men's washrooms: 1168 mm
Ladies washrooms: 1118 mm
Children's washrooms, 3-9 years: 813 mm
Children's washrooms, 9-12 years: 914 mm
Children's washrooms, 12-15 years: 1016 mm
Children's washrooms, 15-18 years: 1118 mm
*Bottom of the dryer base plate to the washroom floor!